Installation Instructions

PIVOT KIT UNIVERSAL INSTALLATION

With the versatility of the PIVOT KIT UNIVERSAL, you may mount the kit onto any available flat surface (vertical, horizontal or otherwise).  The following instructions are provided (illustration provided for reference):

1. Mount kit from trunk with screws ‘D’ or ‘E’ - may require drilling 3/16” holes (2X);

2. Washers ‘H’ provided for water seal;

3. Alternative Mount with self-tapping screws ‘I’ only where access from trunk is not possible;

4. Double sided adhesive strip provided as a gasket between bracket and tail;

5. Mount plate with ‘K’ and ‘L’;

6. Hex Key provided (5/32”) for quick preload adjustability of pivot mounts. If ON-THE-FLY control is not desired, apply full preload.

Click here for an image of the
Parts legend included with the PIVOT KIT UNIVERSAL

PIVOT KIT UNIVERSAL – TURN SIGNAL BRACKET INSTALLATION

Turn Signal Brackets are a great way to add those sleek new short stalks to your PIVOT KIT UNIVERSAL. The brackets are modular in design and simply replace the standard brackets on the kit. Most aftermarket short stalks are fully compatible with the brackets (Max Stud Diameter 0.394” or 10 mm). Check out our selection of turn signal short stalks – fully compatible with all PIVOT KITs.
 

7. Unscrew Standard Plate Brackets (both sides);

8. Replace with turn signal brackets using same hardware;

9. Remount plate;

10. Mount Turn Signals onto bracket;

11. Tighten all screws to lock into position
    
     

Click here for an image of the
Parts legend included with the PIVOT KIT UNIVERSAL with Turn Signal Brackets