Specifications

Dr X Kit 2007 R1 X-treme DIY

• All parts included for hassle free install (including Dremel cutting blades, plastic adhesive, wire tap connectors, heat shrink, tie wraps, rubber bands, stickers and step-by-step color manual).  See installation manual for complete details and pics.

• Installs into OEM Yamaha R1 taillight (Yamaha Part No. 5C8-84710-10) using same mounting holes and screws

• Includes Dr X Kit 2007 R1 X-treme PCB Assembly + VFX Universal Flasher Relay

Dr X Kit 2007 R1 X-treme PNP (Hotswap, CSI or New Taillight)

• All parts included for quick installation (including wire tap connectors, tie wraps and step-by-step color manual).  See installation manual for complete details and pics.

• Dr X Kit 2007 R1 X-treme PCB installed into OEM R1 taillight (Yamaha Part No. 5C8-84710-10) by VFX technicians (CSI, Hotswap or New taillight)

• Each PNP kit is tagged with a serial number for process traceability

• Includes Dr X Kit 2007 R1 X-treme taillight assembly + VFX Universal Flasher Relay

Dr X Kit 2007 R1 X-treme FX Switch (VFX No. XSBA-413)

• Sleek SPDT bat switch for activation

• LEDs to confirm activation of either F1 or F2 Functions

• Connectorized for easy PLUG ‘n PLAY installation with Dr. X Kit

• Custom Wire Harness with flexible high temperature black mesh sheathing

• Integrated fuse and fuse holder for short circuit protection

• All electronics completely potted for weather proof seal

• Designed for discrete panel mounting

• See installation manual for complete details and pics

____________________

Sub-Component specifications:

Dr X Kit 2007 R1 X-treme PCB Assembly (VFX No. XYR1-207-PCB)

• Direct Replacement for stock circuit assembly

• Total of 83 LEDs per assembly (only 21 LEDs in stock assembly)

• Circuit boards manufactured to commercial IPC specifications

• Each circuit board electrically tested (Probot tested) for trace integrity

• Components machine assembled via pick & place robotics, reflow ovens and wave soldering for ultimate in reliability

• Boards coated with BLACK enamel for clean/sleek appearance

• Centralized wire bus for easy feed through of wires at base of taillight - uses same exit hole as OEM board

• Wires color matched with OEM for easy install

• Assembly footprint and mounting holes identical to OEM for easy install

Plastic Adhesive (VFX No. VPAD-010)

• Formulated by VFX engineers specifically for re-sealing taillights

• One part adhesive - ready to use, no mixing required (DIY)

• Easy squeeze dispensing pouch - users can control opening and flow (DIY)

• Similar viscosity as honey - great for filling gaps without running (DIY)

• Impermeable to elements (i.e. water, gasoline, oil, road grime and outdoor temperatures)